LAON MEDI

CBCT & Scan data matching

Select the CBCT function on the left.
💁🏻 TIP Set three alignment points, one in the maxillary left posterior, one in the anterior, and one in the maxillary right posterior. For higher accuracy, place the points on cusps or distinctive features.
Adjust the transparency of CBCT. By adjusting transparency, you can clearly observe the tooth morphology.
Set alignment points! Set points in the same location as the well-visible maxilla in CBCT, aligning three points in the maxilla and three points in the mandible in the same way.
After setting all the points, click the apply button to save. ✅

Fine-tuning 
Select either the maxilla or mandible arch.

In the Model Alignment panel on the right, you can adjust the angle and position of the scan data. 🔃

When you are done, click apply to save it.

🗣 TIP

Adjust the position by entering values for Move_x_y_z / Rotate_x_y_z.
Use the Section view to check if the alignment is accurate by observing the red line (scan data) position.
Adjust the slider to change the position of the cross-section.
Press the buttons to switch the view.